LCX800 Elliptical Trainer - FAQ

In this case, the rollers, the bearings in the rollers, and the rails need to be replaced. The adjustment screw next to the footrest was tightened too much during assembly. For detailed instructions on ordering the required spare parts, see this article: How do I get the spare parts I need?. You will need the part numbers SP_LCX800_121L and SP_LCX800_121R.

In most cases, replacing the screw is sufficient. This is because the threads are often no longer in optimal condition and therefore do not hold as securely as they should. For detailed instructions on ordering the required spare parts, see this article: How do I get the spare parts I need?. You will need the part number SP_LCX800_48

A new power supply unit will probably help. For detailed instructions on ordering the required spare parts, see this article: How do I get the spare parts I need?.

The motor is probably defective. Please contact a technician or order a replacement motor. For detailed instructions on ordering the required spare parts, see this article: How do I get the spare parts I need?.

We cannot provide this password. Entering it will erase the entire operating system of your sports equipment, after which a new operating system will need to be installed.

If noise is coming from the footplate area, the bearings in the guide rollers on the footplate may be defective. This can happen because the bearings in the rollers are subject to a certain amount of wear. You can order the rollers, including the footplate, as spare parts:

• sp_lcx800_47_new+ 2x sp_lcx800_35
• the complete footplate
• sp_lcx800_121l left side
• sp_Lcx800_121r right side